Pulse filter in IR2125

I am trying to implement the chip IR2125 as follows : http://www.infineon.com/dgdl/ir2125.pdf?fileId=5546d462533600a4015355c85ba31694

But I have been unable to find what kind of pulse filter is being used in this controller. Could anybody help me with the same?

Thank you so much.

Regards,

Vanchi

Replay

Category: integrated circuit Time: 2016-07-28 Views: 0

Related post

  • Bootstrap circuit for high-side MOSFET driver 2014-11-03

    I am very familiar with the operation of bootstrap drivers on MOSFET driver ICs for switching an N-channel high-side MOSFET. The basic operation is covered exhaustively on this site and others. What I don't understand is the high-side driver circuitr

  • What is the circuit for the PMOS driver found in synchronous buck regulator ICs? 2015-07-18

    Some synchronous buck regulator ICs sport a NMOS lowside switch and a PMOS high side switch. I understand why these use a PMOS/NMOS pair instead of a NMOS/NMOS pair, but I can't seem to make sense of how one would drive the PMOS at 1MHz without signi

  • How to tell film capacitor type 2016-06-13

    How do you tell what type a capacitor is, (e.g. MKT, MKP, Mylar)? Most capacitors probably don't have a datasheet. Also, if the capacitor has no markings/code, for example: is it possible to guess the type of the capacitor? --------------Solutions---

  • Filter 5v pulse from micro input 2014-02-03

    I am monitoring an external system which sends out a 5v pulse every 2 seconds when in normal mode. When the motor is working, it sends out a constant 5v designed to power a flashing light or LEDs as a warning system. When the pulse is not present, it

  • Simple logic circuit to filter out the even numbered pulse? 2013-09-05

    I need a logic circuit to have a function as shown in the figure: An input signal applied to the input end, I want it to only output the odd numbered pulse and output 0 for the even numbered pulse. To simplify this question, assume the input signal i

  • What's the sharpest frequency response for a non-causal low-pass filter whose step response doesn't overshoot? 2011-05-08

    Butterworth, Bessel, Chebychev, and sinc low-pass filters are used in various cases where there are different tradeoffs between having a uniformly-decreasing frequency response, a uniform phase response, a steep cutoff, or "brick-wall" response.

  • What is the best way to filter out noise on data line? 2011-07-20

    I am working on a product that has a controller connected to a device via an 8 conductor cable (an ethernet cable). The cable length varies depending on where the device is installed but the length varies from 15 to 30 feet. The device being controll

  • How do I smooth out the voltage from a pulse-charger? 2011-08-25

    I've got a dc-dc pulse charger that charges my 12v lead acid battery. The pulse charger charges for 1 second and stops for 20 milliseconds. My battery is powering some sensitive equipment, what can I do to make sure my 12v battery is always outputtin

  • Designing a low-pass filter 2011-10-04

    I want to design a low pass filter with common-mode choke that has a cutoff frequency of 100 Hz. This is going to be used in a bus 24V DC power system that will deliver 10A to the load. I want to use it to clear EMI, RF interference and noises. Since

  • Converting an analog signal of varying maximum and minimum values to a series of pulses 2011-11-01

    I have a situation where I need to convert an analog waveform into a series of pulses. The generated signal will be coming from an IR LED/photo-transistor pair that will output a signal whose maximum and minimum value will depend on the person whose

  • What type of filter? 2011-11-07

    I have a signal that is 3mV range, I like to use a bandpass filter for this signal at 800Khz to eliminate unwanted signals (i.e. noise etc) I have the following questions: Since the amplitude of my signal is small, shall I amplify first? (Just pass t

  • Connect Ubuntu Server directly to DSL filter 2012-01-02

    I want to replace my Broadband router (Speedport W 701V with integrated DSL modem) with a Ubuntu server equipped with a dual port network interface. Can I connect the server directly to the DSL filter? I guess the answer is no and I need a DSL modem

  • Wideband Passband RF filter 2012-02-16

    I require a passband filter with bandwidth of 500 MHz. 4 GHz central frequency. minimize the attenuation of the signal (but there is no restriction on this as I am going to use power amplifiers after the filters to increase the signal strength). Can

  • Using a pulse sensor with Arduino, is it possible to code in Actionscript? 2012-03-24

    I'm attempting to construct a program that will read pulse through a pulse sensor I have hooked up to my Arduino Duemilanove Board. Easy enough right? OK...but I'm trying to code it using Actionscript. I've already got the serproxy and all that mess

  • How to configure an analog filter(s) to maximally smooth out a 100 Hz PWM signal from a LED controller 2012-03-29

    I have an RGB LED controller which controls the brightness using a 100 Hz PWM, seemingly without any built-in smoothing at all. (recorded it with a soundcard, and those pulses are 100 percent rectangular. :) I want the resulting voltage coming to LED

  • how determine the RC time constant in PWM digital to analog low-pass filter? 2012-07-01

    I 'm looking for the best RC time constant and its reason in a PWM to convert digital signal to analog based on duty-cycle and frequency and other parameters. PWM frequency is 10 kHz. --------------Solutions------------- The best RC is infinite, then

  • Detecting and counting signals in list data: checking pulse rate 2012-08-02

    Hope this isn't too much of a basic question: I'm looking for some Mathematica functions, but I don't know which ones. Background I recently read about a simple technique for reading your body's pulse rate using the camera built into the computer (eg

  • WordPress gallery 'post_gallery' filter doesn't work with feeds? 2012-09-03

    We can use the post_gallery filter to modify/replace the default WordPress gallery template (AKA output code) to suit our needs. But this doesn't seem to affect the markup in RSS feeds. No matter what I do, the markup for gallery images in my RSS fee

  • Is this an RC filter? 2012-09-05

    I'm trying to understand this temperature sensor circuit I came across on a room Air-Conditioner controller (Want to build one myself). The sensor is an NTC type thermistor (15k at 25 deg C). What I collect is that the NTC along with R2 form a voltag

iOS development

Android development

Python development

JAVA development

Development language

PHP development

Ruby development

search

Front-end development

Database

development tools

Open Platform

Javascript development

.NET development

cloud computing

server

Copyright (C) avrocks.com, All Rights Reserved.

processed in 0.184 (s). 13 q(s)